Vent-Axia Lo-Carbon Sylph Series Installation And Wiring Instructions page 4

Continuous extract fan

Table of Contents

Available languages

Fig.1 Continuous trickle with no

remote boost facility (T &TP)

Fig.2 Continuous Boost with no trickle

facility (T, TP, HT, HTP)

Note:- Link must be fitted between L & Ls

Fig.3 Continuous trickle with boost facility via

integral pullcord (TP & HTP)

Note:- Link must be fitted between N & Ls

Fig.4 Continuous trickle with boost

facility via remote switch.

(T, TP, HT & HTP)

C. SETUP

WARNING: THE FAN AND ANCILLARY CONTROL EQUIPMENT MUST BE ISOLATED FROM THE

POWER SUPPLY DURING THE INSTALLATION / OR MAINTENANCE.

Accessing the wiring and control settings – (Fig. 5 and 6)

Fig.5.

1. Loosen screw.

Trickle speed selection (6l/s or 9l/s) – (Fig. 6)

2. Pull grille

slightly away

from bottom

edge.

3. Push grille upwards

until clear from the fan

chassis

Fig.6

Table of Contents