Changing Operator Menu Setup - Siemens SITRANS FM MAG 5000 Operating Instructions Manual

Changing decimal point position
1. Enter the respective totalizer menu.
2. Use select key
3. Use change key
Changing units
Note
Menus disabled on MAG 5000/6000 CT
Due to legal requirements, some parameters are disabled on MAG 5000/6000 CT. Only
available units are m
1. Use select key
2. Press change key
6.6

Changing operator menu setup

In the operator menu the menus required for daily operation of the flowmeter are shown. It is
possible to hide and change some of the menus in the operator menu. This is done in the
operator menu setup menu, see diagram Operator menu setup (Page 92).
Customizing menus in operator menu
To customize the menus in the operator menu perform the following steps:
1. Press top up key
2. Enter password.
3. Use forward key
Changing text in line 1
1. Press lock/unlock key
2. Use change key
3. Press lock/unlock key
Note
If "Text" is selected in line 2, this line functions as a heading for the value shown in line 3.
Otherwise it shows the actual value of the reading selected.
SITRANS FM MAG 5000/6000 IP67
Operating Instructions, 12/2019, A5E02338368-AD
to position cursor below decimal point.
to move decimal point to requested position.
/h and m .
3 3
to position cursor below unit.
until requested unit is displayed.
for 2 sec.
or backward key
to unlock setting.
to select desired text.
to confirm selected text.
6.6 Changing operator menu setup
to reach operator menu.
Commissioning
47