Menu Structure - Siemens SITRANS FM MAG 5000 Operating Instructions Manual

Keypad
The keypad is used to set the flowmeter. The keys function as follows:
TOP UP KEY
FORWARD KEY
BACKWARD KEY
CHANGE KEY
SELECT KEY
LOCK/UNLOCK
KEY
6.3

Menu structure

Note
Menus disabled on MAG 5000/6000 CT
Due to legal requirements, some parameters are disabled on MAG 5000/6000 CT.
The menu is built up of two parts. An operator menu and a setup menu, see Transmitter menu
overview (Page 79).
Operator menu
The operator menu is for daily operation. It is customized in the operator menu setup. The
transmitter always starts up in operator menu No. 1. The forward
are used to step through the operator menus.
Setup menu
The setup menu is for commissioning and service only. Access to the setup menu is gained by
pressing the top up key
● View mode
● Setup mode
View mode is a read-only mode. The pre-selected settings can only be scanned.
Setup mode is a read and write mode. The pre-selected settings can be scanned and changed.
Access to the setup mode is password-protected. The factory set password is 1000.
Access to a submenu in the setup menu is gained by pressing the lock key
up key
return to operator menu No. 1.
SITRANS FM MAG 5000/6000 IP67
Operating Instructions, 12/2019, A5E02338368-AD
This key (when held for 2 sec.) is used to switch between op‐
erator menu and setup menu. In transmitter setup menu, a
short press will cause a return to previous level.
This key is used to step forward through the menus. It is the
only key normally used by the operator.
This key is used to step backwards through the menus.
With this key settings or numerical values are changed.
With this key figures to be changed are selected.
This key enables the operator to change settings and it gives
access to submenus.
for 2 seconds. The setup menu operates in two modes:
briefly to return to the previous menu. Press longer (2 sec.) to exit the setup menu and
Commissioning
6.3 Menu structure
and the backward keys
. Press the top
43