Maintenance; Operation - The Handy THSS80 Instruction Manual

MAINTENANCE

LUBRICATE
Maintenance spray or multi-purpose grease can be applied to the wheel axle prior to long-term
storage. Oiling is not necessary.
GEARBOX
DO NOT open the gearbox. The gears are permanently lubricated at the factory and do not need
lubricating.
CHECK TYRE INFLATION
Prior to using the Spreader, ensure the tyres are sufficiently inflated. We recommend the use of
FOOT or HAND inflation devices only. Do not inflate above 25psi.
CLEANING
After each use thoroughly wash the spreader and clean material out of the hopper.
STORING
Never allow material to stay in the hopper for extended periods. Before storing, ensure that the
spreader is clean & dry. Store indoors or a protected area during severe weather & winter months.
CHECK ALL NUTS, BOLTS AND FASTENING
Periodically check all fastenings are tight & secure.
NEVER EXCEED LOAD CAPACITY
To avoid damaging the spreader, never exceed the rated load capacity of 36kg
ONLY USE MANUFACTURER APPROVED PARTS
If a part needs replacing, only use the manufacturer's original parts. Non-original replacement parts
will invalidate your warranty and may result in a safety hazard or poor operation.

OPERATION

DANGER
The product must only be put into operation if no defects are found. It is crucial that defective
parts are replaced before the product is used again. Check the safety equipment and the safe
condition of the product: Check all parts to make sure that they fit tightly. Check whether there
are any visible defects: broken parts, cracks, etc.
DANGER
DO NOT EXCEED THE EQUIPMENT MAXIMUM LOAD CAPACITY OF 36KG
Before filling the hopper, familiarise yourself with the operation of this Spreader.

Move the stop bolt on the rate gauge assembly to the proper setting.

To stop, push the lever forwards to close the flow hole before you stop moving.

When finished, remove any remaining material from hopper.

Thoroughly wash the spreader and allow it to dry before storing. No oiling is necessary

If the Spreader does not spread evenly, ensure that the FRONT of the gearbox points towards
the front of the Spreader. The impellor must rotate clockwise.

Material which is stuck on the impellor blades will cause uneven spreading.

Remove the agitator when using refined de-icing salt materials to reduce gearbox damage. DO
NOT USE ROCK SALT.

If fertiliser is accidentally deposited too heavily in a small area, soak the area thoroughly with a
garden hose or sprinkler to prevent burning the lawn.

When broadcasting weed control fertilisers, make sure the broadcast pattern does not hit
evergreen trees, flowers or shrubs.

Always use the rain cover in wet weather conditions to keep the hopper contents dry.