The Handy THSS80 Instruction Manual page 8

STEP 2

Attach the Wheel Assembly Frame to each side of the Gearbox Assembly and Fixing Connecting
Rod, insert two bolts M6x35 into the fixing connecting rod through the Wheel Assembly Frame.

Make sure the hole in the Gearbox Axle is on the RIGHT SIDE, when assembling, as shown.

Attach the Wheel Assembly Frames & Support Leg onto the Hopper using bolts M6x70, M6 Lock
Nuts and Large Flat Washers Ø6.
NOTE: WE ADVISE YOU DO NOT TIGHTEN THE NUTS & BOLTS COMPLETELY AT THIS POINT.
Bolt
M6x35
Bolt M6x35
Connect the two wheel
frames to the axle using
M6x35 bolts
Big Flat Washer Ø6