Data Memory; Viewing The Stored Values; How Not To Store A Reading; Memory Full - Microlife aponorm Mobil Soft Control Manual

6. Data Memory

At the end of a measurement, this instrument automatically stores
each result, including date and time.

Viewing the stored values

Press the M-button 5 briefly, when the instrument is switched off.
The display first shows „M", and then a value, e.g. „M17". This
means that there are 17 values in the memory. The instrument then
switches to the last stored result.
Pressing the M button again displays the previous value. Pressing
the M button repeatedly enables you to toggle between one stored
value and another.

How not to store a reading

Press the ON/OFF button while the reading is being displayed.
Keep the button pressed until „M" is flashing and then release it.
Confirm by pressing the M button.
24

Memory full

Pay attention that the maximum memory capacity of 30 is not
exceeded. When the memory is full, the old values are
automatically overwritten with new ones. Please show
the values to a doctor or enter them in a blood pressure pass
for evaluation before the memory capacity is reached and the
values are overwritten and can no longer be retrieved.

Clear all values

If you are sure that you want to permanently remove all stored
values, hold down the M button (the instrument must have been
switched off beforehand) until „CL" appears and then release the
button. To permanently clear the memory, press the M button while
„CL" is flashing. Individual values cannot be cleared .