Download Print this page
Phonak CROS II Desktop Fitting Manual

Phonak CROS II Desktop Fitting Manual

Advertisement

Quick Links

Phonak CROS II
March 2015
Desktop Fitting Guide
This guide provides you with a detailed introduction to fitting a Phonak CROS II system in Phonak Target 4.1 and later. For fitting of the
hearing instruments, please see the Hearing Instruments Desktop Fitting Guide.
Preparation of the hearing instruments
For the fitting of CROS II it is recommended to use iCube II as it enables faster fine tuning and instant demonstration of CROS II.
iCube II
No cables to the hearing instrument or CROS II are needed. Insert
the battery before placing the device on the ear. Turn on the
devices by closing the battery compartment.
Connect the instruments
Click [Connect] to start the fitting. The connected devices will appear next to the
fitting device in the dashboard.
The audiogram data from NOAH will be automatically imported into Phonak Target
and taken into account for the pre-calculation.
Basic tuning
After the connection, fit the hearing instrument as in a monaural fitting. After the
successful fitting, go to the [Basic tuning] screen to adjust the loudness ratio
between CROS II and the hearing instrument.
For a BiCROS fitting, run the feedback test.
The hearing instrument on the better ear can be adjusted in the same way as in a
standard fitting.
NOAHlink or HI-PRO
Connect the programing cables to the hearing instruments and the
fitting device. CROS II is not active with the fittng cables
connected.
Confirm that the correct fitting device is shown. To change the
fitting device, use the pull down arrow next to the fitting device
in the dashboard.

Advertisement

loading
Need help?

Need help?

Do you have a question about the CROS II and is the answer not in the manual?

Questions and answers

Summary of Contents for Phonak CROS II

  • Page 1 March 2015 Desktop Fitting Guide This guide provides you with a detailed introduction to fitting a Phonak CROS II system in Phonak Target 4.1 and later. For fitting of the hearing instruments, please see the Hearing Instruments Desktop Fitting Guide.
  • Page 2 You can close the session at any time by clicking [Save & close session] in the top right corner of the screen. The save dialog will confirm the successful save of the CROS II fitting. After the save, Phonak Target will guide you to the start screen.