Phonak CROS II Desktop Fitting Manual

Phonak CROS solutions
February 2018
Desktop Fitting Guide
This guide provides you with a detailed introduction to fitting a Phonak CROS II or a Phonak CROS B system in Phonak Target
5.3 and later. For fitting of the hearing instruments, please see the Hearing Instruments Desktop Fitting Guide.
Preparation of the hearing instruments
For the fitting of CROS II or CROS B it is recommended to use iCube II as it enables faster fine tuning and instant
demonstration of the CROS system.
CROS II can only be fit with Venture hearing instruments.
CROS B can only be fit with Belong™ hearing instruments.
iCube II
No cables to the hearing instrument or CROS device are
needed. Insert batteries before placing the devices on the ear.
Turn on the devices by closing the battery compartment.
Connect the instruments
Click [Connect] to start the fitting. The connected devices will appear
next to the fitting device in the dashboard.
The audiogram data from NOAH will be automatically imported into
Phonak Target and taken into account for the pre-calculation.
After the connection, select the correct acoustic parameters for your
hearing instruments.
NOAHlink or HI-PRO
Connect the programing cables to the hearing instruments
and the fitting device. It is not possible to demonstrate the
CROS device with the cables connected.
Confirm that the correct fitting device is shown. To change the
fitting device, use the pull down arrow next to the fitting device
in the dashboard.