Specifications - SMC Networks ZXP7 Series Operation Manual

3. Specifications

3.1. Specifications
■Product specifications
Mounting
Fluid
Operating temperature range[°C]
Mass [g] note1)
Common
Max. workload [kg] Note2)
Impact / Vibration resistance [m/s
Note3)
Air supply port(P)
Power supply voltage
Max. vacuum pressure [kPa] note4)
Max. suction flow [L/min(ANR)] note4)
Vacuum
Air consumption [L/min(ANR)] note4)
ejector
Supply pressure range [MPa]
Standard supply pressure [MPa]
Rated pressure range [kPa]
Accuracy (Ambient temperature at
25°C)
Pressure
Linearity [%]
sensor
Repeatability [%]
Temperature characteristics [%]
Applicable suction cups
Note 1) For the mass of the suction cup, add the mass of the suction cup with the adapter.
( ) indicates the weight without cup or cup mounting flange.
Note 2) Limited by the cup diameter, mounting orientation or workpiece. The mass of the workpiece shall be maximum workload
or less.
Adsorption or transfer of workload exceeding the maximum workload leads to the decrease of vacuum due to air leakage.
Note 3) Impact resistance: The characteristics are satisfied after tested one time in each of the X, Y and Z directions without
energization. (Initial value)
Vibration resistance: The characteristics are satisfied after tested a one sweep in each of the X, Y and Z directions at 10
to 500 Hz without energization. (Initial value)
Note4) Values at the standard supply pressure. Values are based on standard of SMC measurements. They depend on
atmospheric pressure (weather, altitude, etc.) and measurement method.
Compliant with "ISO9409-1-50-4-M6"
]
2
[V]
±
-9-
Air
5 to 50
840 (612)
7
150 / 30
One touch fitting (Φ6)
DC24 10%
±
-84
17
57
0.3 to 0.55
0.5
0 to -101
2 F.S. (with rated pressure range)
0.4 F.S.
±
0.2 F.S.
±
0.2 F.S. (Based on 25
±
Refer to "3.4. How to order"
°C)
No. TQ1230001-OM101-A