Standards And Directives Complied With - Siemens XC10 Series Operation

Safety
2.3

Standards and directives complied with

10
Building Technologies
Fire Safety
Disregard of the safety regulations
Before they are delivered, Siemens products are tested to ensure they function
correctly when used properly. Siemens disclaims all liability for damage or injuries
caused by the incorrect application of the instructions or the disregard of danger
warnings contained in the documentation. This applies in particular to the following
damage:
- Personal injuries or damage to property caused by improper use and incorrect
application
- Personal injuries or damage to property caused by disregarding safety
instructions in the documentation or on the product
- Personal injury or damage to property caused by poor maintenance or lack of
maintenance
Disclaimer
We have checked that the content of this document matches the hardware and
software described. Despite this, we cannot rule out deviations and cannot
therefore assume liability for them matching completely. The details in this
document are checked regularly and any corrections needed included in
subsequent editions.
We are grateful for any suggestions for improvement.
A list of the standards and directives complied with is available from your Siemens
contact.
In order to satisfy Directive 89/106/EEC (the Construction Products Directive –
CPD), the firmware of a newly installed fire detection installation must be of at least
the current market package (MP) 2.1.
NOTICE
Firmware version of a newly installed extinguishing installation not
updated
No CPD conformity
- Compare the firmware version of a newly installed fire detection installation
with the firmware version for MP2.1
- Update the firmware if necessary
A6V10257477_c_en_--
2012-06