Safety Regulations For The Method Of Operation - Siemens XC10 Series Operation

Safety
2.2

Safety regulations for the method of operation

8
Building Technologies
Fire Safety
Information about the risk of injury is shown as follows:
WARNING
Nature and origin of the danger
Consequences if the danger occurs
- Measures / prohibitions for danger avoidance
Design for possible damage to property
Information about possible damage to property is shown as follows:
NOTICE
Nature and origin of the danger
Consequences if the danger occurs
- Measures / prohibitions for danger avoidance
National standards, regulations and legislation
Siemens products are developed and produced in compliance with the relevant
European and international safety standards. Should additional national or local
safety standards or legislation concerning the planning, assembly, installation,
operation or disposal of the product apply at the place of operation, then these
must also be taken into account together with the safety regulations in the product
documentation.
Electrical installations
WARNING
Electrical voltage
Electric shock
- Work on electrical installations may only be carried out by qualified
electricians or by instructed persons working under the guidance and
supervision of a qualified electrician, in accordance with the electro technical
regulations
- Wherever possible disconnect products from the power supply when carrying
out commissioning, maintenance or repair work on them.
- Lock volt-free areas to prevent them being switched back on again by mistake.
- Label the connection terminals with external voltage using a 'DANGER External
voltage' sign.
- Route mains connections to products separately and fuse them with their own,
clearly marked fuse.
- Fit an easily accessible disconnecting device in accordance with IEC 60950-1
outside of installation.
- Produce earthing as stated in local safety regulations.
A6V10257477_c_en_--
2012-06