Avaya S8500 Job Aid page 10

Job Aid Replacing the Avaya S8500 Media Server—Release 2.0 and Later
Final tasks
Checklist 5. Final tasks for replacing an S8500 Media Server using the blank hard drive
9
Task
40 Set a timeout value
41 Set the loader watchdog timeout
42 Log off and disconnect from the
RSA
Checklist 6. Final tasks for replacing an S8500 Media Server reusing the original hard drive
9
Task
1 Connect laptop to the media
server
2 Log onto the Maintenance Web
Interface
3 Verify date and time
4 Ping the connections on the
media server
5 Resolve alarms on the media
server
6 Check the health of the media
server
10
555-245-762, Issue 1
Description
On the RSA welcome screen, on the
value field, select no timeout and click Continue. This allows 60
minutes of use before disconnecting.
Under ASM Control, click System Settings. Scroll down to the
Server Timeouts section, and in the
5.0 (minutes) and click Save.
Click Log Off. Once you are logged off, disconnect from the
services port on the RSA.
Description
Connect to the services port on the back of the media server and
wait about 3 minutes before logging in.
Open a browser on your laptop. Type 192.11.13.6 and press Enter
to log onto the Maintenance Web Interface.
Note: Use the initial installation login craft or dadmin and the
initial password.
Under Server, click Server Date/Time. Make changes as
necessary.
Under Diagnostics, click Ping. Ensure that all administered
connections respond.
Under Alarms, click Current Alarms. Compare these against the
recorded alarms from Checklist 3, step 2. Clear any alarms that
appear.
Using a SAT screen, type display alarms
For instructions on resolving alarms, see Maintenance Alarms
Reference, 555-245-102.
Using a SAT screen, type list ipserver-interface and status
health. Check that all connections are working correctly.
Replacing the Media Server with Release 2.0—S8500
Inactive session timeout
field, select
Loader watchdog
and press Enter.
December 2003