Assembly - Pro-Form 760 HR Heart Rate Control User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable spanner
screwdriver
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 22. The number after the parentheses
is the quantity needed for assembly. Note: Some small parts may have been preattached for shipping. If a
part is not in the parts bag, check to see if it has been preattached.
M4 x 12mm
Screw (41)–2
M6 x 8mm Zinc
Button Screw (71)–1
M8 x 52mm Button
Screw (54)–2
1. Orient the Front Stabiliser (15) as shown. While another
person lifts the front of the Frame (1), attach the Front
Stabiliser to the Frame with two M8 x 52mm Button
Screws (54) and two M8 Washers (81).
All manuals and user guides at all-guides.com
.
M4 x 16mm
Screw (57)–6
M8 x 14mm Button
Screw (75)–1
M8 Nylon
Locknut (49)–2
M8 x 22mm Button
Screw (59)–4
M8 x 70mm Button
Screw (68)–4
1
1
81
5
and Phillips
M8 Washer
(81)–2
M8 x 39mm Button
Bolt (52)–2
15
81
54