Table of Contents
Advertisement
Figure 7-3. Take a Photo via Client
7 . Confirm to add the person .
• Click Add to add the person and close the Add Person window .
• Click Add and New to add the person and continue to add other persons .
7.4.6. Collect Face via Access Control Device
When adding person, you can collect the person's face via access control
device added to the client which supports facial recognition function .
Steps
1 . Enter Person module .
2 . Select an organization in the organization list to add the person and click
Add .
NOTE
Enter the person's basic information first. For details about configuring
person's basic information, refer to Configure Basic Information.
3 . Click Add Face in the Basic Information panel .
4 . Select Remote Collection .
5 . Select an added access control device or the enrollment station from the
drop-down list .
NOTE
If you select the enrollment station, you should click Login to set related
parameters of the device including IP address, port No., user name, and
password. Also, you can check Face Anti-Spoofing and select the live-
ness level as Low, Medium, or High.
Face Anti-Spoofing
If you check this function, then the device can detect whether the face to be
collected is an authentic one .
66
6 . Collect face .
a) Face to the camera of the selected access control device and make
sure your face is in the middle of the collecting window .
b) Click
to capture a photo .
c) Click OK to save the captured photo .
7 . Confirm to add the person .
• Click Add to add the person and close the Add Person window .
• Click Add and New to add the person and continue to add other persons .
7.4.7. Configure Access Control Information
When adding a person, you can set her/his access control information, such
as binding an access control group with the person, configuring PIN code, set-
ting the person as a visitor, a blacklist person, or a super user, etc .
Steps
1 . Enter Person module .
2 . Select an organization in the organization list to add the person and click
Add .
3 . In the Access Control area, click to select access group(s) for the per-
son .
NOTE
For details, refer to Set Access Group to Assign Access Authorization
to Persons.
Figure 7-4. Configure Access Control Information
4 . Set a unique PIN code for the person which can be used for access au-
thentication .
• Manually enter a PIN code containing 4 to 8 digits .
NOTE
Persons' PIN codes cannot be repeated.
• Click Generate to randomly generate an unrepeated PIN code of 6 digits .
NOTE
If there are repeated PIN codes, a prompt will pop up on the client. The
admin can generate a new PIN code to replace the repeated PIN code
and notify related persons.
67
Advertisement
Table of Contents
