Terminal Description; Wire Normal Device - ATN Thermal Entry Wizard Manual

If the cable size is 12 AWG, you should use a 12 V power supply. And the
distance between the power supply and the device should be no more
than 40 m.

4.1. TERMINAL DESCRIPTION

The terminals contains power input, alarm input, alarm output, RS-485, Wie-
gand output, and door lock .
The terminal's diagram is as follows:
Figure 4-1. Terminal Diagram
18
The descriptions of the terminals are as follows:
Table 4-1. Terminal Descriptions
Group No. Function Color
A1 Red
Group A Power Input
A2 Black
B1 Yellow/Blue
B2 Alarm Input Yellow/Black
B3 Yellow/Orange
Group B
B4 Yellow/Purple
B5 Alarm Output Yellow/Brown
B6 Yellow/Red
C1 Yellow
Blue
C2 RS-485
C3 Black
C4 Green
Group C
C5 White
C6 Brown
Wiegand
C7 Orange
C8 Purple
C9 Gray
D1 White/Purple
D2 White/Yellow
Group D D3 Door Lock White/Red
D4 Yellow/Green
D5 Yellow/Gray

4.2. WIRE NORMAL DEVICE

You can connect the terminal with normal peripherals .
Follow the diagram below to wire the thermographic module and the device
main body:
The wiring diagram without secure door control unit is as follows .
Name Description
+12 V 12 VDC Power Supply
GND Ground
IN1 Alarm Input 1
GND Ground
IN2 Alarm Input 2
NC Alarm Output
COM
Wiring
NO
485+ RS-485 Wiring
485-
GND Ground
W0 Wiegand Wiring 0
W1 Wiegand Wiring 1
WG_OK Wiegand Authenticated
WG_ERR Wiegand Authentication Failed
BUZZER Buzzer Wiring
TAMPER Tampering Alarm Wiring
NC Lock Wiring (NC)
COM Common
NO Lock Wiring (NO)
SENSOR Door Contact
BTN Exit Door Wiring
19