Table of Contents
Advertisement
5 . Select Local as the card issuing mode .
Figure 7-2. Issue a Card by Local Mode
6 . Set other related parameters .
Card Enrollment Station
Select the model of the connected card enrollment station .
NOTE
Currently, the supported card enrollment station models include
DS-K1F100-D8, DS-K1F100-M, DS-K1F100-D8E, and DS-K1F180-D8E.
Card Type
This field is only available when the model is DS-K1F100-D8E or DS-
K1F180-D8E . Select the card type as EM card or Mifare card according to the
actual card type .
Buzzing
Enable or disable the buzzing when the card number is read successfully .
Card No. Type
Select the type of the card number according to actual needs .
M1 Card Encryption
This field is only available when the model is DS-K1F100-D8, DS-K1F100-
D8E, or DS-K1F180-D8E . If the card is M1 card, then you can enable the M1
Card Encryption function and select the sector of the card to encrypt .
7 . Click OK to confirm the operation .
8 . Place the card on the card enrollment station and click Read to get the
card number . The card number will display in the Card No . field automat-
ically .
9 . Click Add .
The card will be issued to the person .
64
7.4.4. Upload a Face Photo from Local PC
When adding person, you can upload a face photo stored in local PC to the
client as the person's profile .
Steps
1 . Enter Person module .
2 . Select an organization in the organization list to add the person and click
Add .
NOTE
Enter the person's basic information first. For details about configuring
person's basic information, refer to Configure Basic Information.
3 . Click Add Face in the Basic Information panel .
4 . Select Upload .
5 . Select a picture from the PC running the client .
NOTE
The picture should be in JPG or JPEG format and smaller than 200 KB.
6 . Optional: Enable Verify by Device to check whether the facial recognition
device managed in the client can recognize the face in the photo .
7 . Confirm to add the person .
• Click Add to add the person and close the Add Person window .
• Click Add and New to add the person and continue to add other persons .
7.4.5. Take a Photo via Client
When adding a person, you can take a photo of the her/him via the client and
set this photo as the person's profile .
Before You Start
Make sure PC running the client has a camera or you have connected other
USB camera to the PC .
Steps
1 . Enter Person module .
2 . Select an organization in the organization list to add the person and click
Add to enter Add Person window .
NOTE
Enter the person's basic information first. For details, refer to Config-
ure Basic Information.
3 . Click Add Face in the Basic Information area .
4 . Select Take Photo to enter Take Photo window .
5 . Optional: Enable Verify by Device to check whether the captured face
photo can meet the uploading requirements .
6 . Take a photo .
a) Face to the camera and make sure your face is in the middle of the col-
lecting window .
b) Click
to capture a face photo .
c) Optional: Click
to capture again .
d) Click OK to save the captured photo .
65
Advertisement
Table of Contents
