Cutting The Roll Paper - Epson SC-F500 Series User Manual

SC-F500 Series User's Guide

Cutting the Roll Paper

Auto Cut
Auto Cut is set to On for the printer by default. When
On is set, the roll paper is cut automatically at the
following times.
❏ When the leading edge is detected as not horizontal
After the roll paper is loaded, the leading edge part
is cut straight.
❏ When printing of one page is finished
The roll paper is cut before printing of the next page
starts.
If you do not want to cut each page or you want to cut at a
desired position, see the following procedure.
Cutting after Last Page Printed or at
Desired Position
Turn off auto cut in the printer driver, print, and then
cut using the Feed/Cut Paper menu of the printer after
printing finishes.
A
Select Off in Advanced - Roll Paper Option -
Auto Cut of the printer driver and then print.
Leave the auto cut setting of the printer on.
Note:
❏ The auto cut setting of the printer driver has
priority over that of the printer. The auto cut
setting of the printer driver is reset to the
default setting of Normal Cut when the
application closes.
❏ To turn off auto cut for HP-GL/2 mode
printing, turn off the auto cut setting on the
printer. Touch the Roll paper information
area - Advanced Media Setting - Auto Cut -
Off from the Home screen. The change to the
setting is saved as a setting of the currently
selected paper type.
B
Touch the Roll paper information area - Feed/
Cut Paper from the Home screen of the printer
after printing finishes.
Use the buttons displayed on the screen to cut
and feed the paper.
Loading and Setting the Paper
Cutting paper with scissors
If you want to cut the paper with your scissors, follow the
steps below to print a cutting line.
c
❏ Do not use a cutter. The printer may be
28
When cutting at the printer default cut
position (right after the bottom margin)
Touch the (Cut) button. The paper is cut and
the paper leading edge returns to the print wait
position.
When cutting at desired position
Hold down the (Forward) or
(Backward) button until the position you want
to cut reaches the position of the dotted line in
the figure.
You cannot set the cutting position further
inside than the bottom margin.
Touch the (Cut) button.
The paper is cut.
Note:
When the length of in the figure is shorter than
the following length, the paper is fed automatically
until the required length is obtained at the time of
cutting.
❏ Sublimation transfer paper: 100 mm
Important:
damaged.