Epson SC-F500 Series User Manual page 124

SC-F500 Series User's Guide
Is the print head scuffing the printed surface?
o
Enable the Thick Paper function, and try printing.
From the Home screen, touch Settings - Printer
Settings - Thick Paper - On.
If the problem does not improve even after enabling
the Thick Paper function, register it as custom paper,
and try changing the Platen Gap to the maximum
setting.
Register the custom paper in Settings - General
Settings - Printer Settings - Custom Paper Setting.
"General Settings - Printer Settings" on page 93
U
Perform Platen Gap settings from the Roll paper
information area - Advanced Media Setting - Platen
Gap on the home screen.
"Roll Paper menu" on page 85
U
Is the print head scuffing the edge of the
o
paper?
If smearing or soiling occurs on the edge of the roll
paper, touch the Roll paper information area -
Advanced Media Setting - Top/Bottom Margins
from the Home screen, change the edge setting to 45
mm, and try printing.
Is the print head scuffing the trailing edge of
o
the paper?
Depending on the paper usage, storage conditions,
and the content of the print data, the bottom edge
may be scuffed when printing. In this situation it is
best to create your data with a wider bottom margin.
Roll paper and cut sheets are smeared
in similar ways
Follow the steps below to clean the roller by feeding
plain paper.
A
Turn on the printer, and load it with the widest
available roll paper.
"Loading Roll Paper" on page 26
U
B
Touch Paper Setting - Roll Paper - Feed/Cut
Paper from the Home screen.
C
Touch and hold the
the paper is no longer marked.
Paper is fed while the
touched. If the paper is not soiled, cleaning is
complete.
Problem Solver
(Forward) button until
(Forward) button is
124
D
Touch the (Cut) button to cut the paper.
Smearing occurs when printing from
the auto sheet feeder
When feeding from the auto sheet feeder for printing,
the printed side may be smeared or color unevenness
may occur. This is more likely to occur when using
glossy paper.
When vertical smearing occurs on glossy paper, we
recommend feeding and printing one sheet at a time
from Cut Sheet(1 sheet) instead of using the auto sheet
feeder.
"Loading Cut Sheet(1 sheet)" on page 34
U
Follow the steps below to clean the roller for the auto
sheet feeder by feeding plain paper.
A
Turn on the printer and load a few sheets of
A3-size plain paper in the auto sheet feeder.
"Loading paper into the auto sheet feeder"
U
on page 31
B
From the Home screen, touch Settings -
Maintenance - Paper Guide Cleaning.
C
Touch Start.
The paper is ejected.
D
Check if the ejected paper is smeared.
❏ If it is smeared: Touch Run Again if the paper is
smeared.
❏ If it is not smeared: Touch Done to finish
cleaning the roller.
The paper is wrinkled.
Are you using the printer at normal room
o
temperature?
Epson special media should be used at normal room
temperature (temperature: 15 to 25˚C, humidity: 40 to
60%). For information about paper such as thin paper
from other manufacturers that requires special
handling, see the documentation supplied with the
paper.