Epson SC-F500 Series User Manual page 27

SC-F500 Series User's Guide
E
Place the roll paper on a flat surface and then
insert the spindle.
With the black flange is on the right, orient the
roll paper so that the leading edge is as shown in
the figure below.
F
Push the flange to the roll paper until there is no
gap between the flange and roll paper.
G
Attach the transparent flange and push it until
there is no gap between the flange and roll paper.
If there are gaps between the flanges at both ends
and the roll paper, the paper may be fed skewed
resulting in an error.
H
Place the spindle shaft into the left and right
grooves on the spindle holder with the black
flange of the spindle on the right.
Loading and Setting the Paper
I
J
K
L
27
Check that the leading edge of the roll paper is
not bent and then insert it into the paper slot until
you hear a beep.
c
Important:
Hold the edges of the paper and insert it
straight into the paper feed slot. Inserting it
skewed will cause a skew error or paper jam.
Note:
If the leading edge of the roll paper is not horizontal
or not cut cleanly, it will be cut automatically after
loading completes. However, it will not be cut if
Auto Cut is set to Off.
Close the roll paper cover and cut sheet cover.
On the displayed screen, set the paper type that
matches the loaded paper and set remaining
amount management if necessary.
Not setting the appropriate paper type will cause
print quality trouble. See the following for more
details on the paper types and the remaining
amount management setting.
"For Roll Paper" on page 35
U
If the optional stand is attached, make sure the
paper basket is open.
Note:
Close the paper basket before printing banners or
other documents of sizes that will not fit in the
paper basket. Before the paper ejected from the
printer touches the floor, we suggest that you take it
in both hands close to the paper eject slot and
continue to lightly support it until printing is
complete.