Xerox DOCUCOLOR 12 Materials Usage Manual page 42

USAGE GUIDELINES FOR XEROX COLOR COPIERS AND PRINTERS
Contact your local authorized Xerox distributor, or call Xerox at 1-800-822-2200 in the USA,
38
•
If attempting to run two sided copies, run the side with the
lightest image, or the side with no color (black-only) on side
one, and the higher density, or the color image on side two.
Load the side one copies in the (Also Called Tray 5) so that the
trail edge of side one is used as the lead edge for side two.
While running side two, continuously monitor the copies as
they exit the machine. Look at the back side (side one) of the
copy to see of any image offsetting has occurred. If offsetting
is seen, stop the job immediately and clean the fusing system.
This condition will only get worse if more copies are run.
To clean the fusing system, run about 10 blank sheets of paper
through the machine. When the bottom side of the blank
sheets comes out clean, continue to run the side two copies.
To run a large quantity of two-sided copies, you may need to
intersperse short runs of two-copies between single-sided
runs to keep the fusing system from becoming contaminated
again.
•
Dry ink coverage on electronic originals should be limited to a
total of 280% (70% for each color). Higher dry ink coverage
can result in poorly fused prints.
If using a coated paper that has not been recommended, first try a
small quantity to test its performance, then consult your local Xerox
representative for agreement on its use.
or 1-800-668-0199 in Canada for our full line of media.
COLOR MATERIALS USAGE GUIDE