Table of Contents
Advertisement
Without sufficient cooling water, the engine, the water pump,
and other components will overheat and suffer damage.
Provide a sufficient supply of water to the water inlets during
operation.
1. Ensure that the driveshaft bearing on the jet drive is
lubricated. Refer to Maintenance ‑ Lubrication Points.
2. Open the fuel tank vent screw, located in the filler cap, on
manual venting type fuel tanks.
3. Position the fuel line primer bulb so the arrow on the side of
the bulb is pointing up. Squeeze the fuel line primer bulb
several times until it feels firm.
eng
OPERATION
NOTICE
27348
55
28664
19748
Advertisement
Table of Contents
