Table of Contents
Advertisement
NOTE: The inside holes on the transom reinforcement plate are
for the lower transom bolts and the outside holes are for the
upper transom bolts.
a -
Large transom washer
b -
Transom reinforcement plate
1. Apply marine sealer to shanks of bolts, not the threads.
2. Fasten the outboard with the correct mounting hardware.
Tighten locknuts to the specified torque.
NOTE: For more accurate torque, whenever possible, turn/
tighten the mounting locknuts rather than turn the mounting
bolts.
e
d
eng
OUTBOARD INSTALLATION
a
c
a -
Flat washer (4)
b -
1/2 in. diameter bolt (4)
c -
Shank of bolt
d -
Flat washer (4)
e -
Locknut (4)
a
b
3729
101
b
33962
Advertisement
Table of Contents
