Table of Contents
Advertisement
iii. Reconnect the vent hose onto the grease fitting after
greasing.
a -
Grease fitting
b -
Vent hose
NOTE: After 30 hours of operation, pump in extra grease to purge
out any moisture. Visually inspecting the purged grease at this
time will give an indication of conditions inside the bearing
housing. A gradual increase in moisture content indicates seal
wear. If the grease begins to turn a dark, dirty gray color, the
driveshaft bearing and seals should be inspected and replaced if
necessary. Some discoloration of the grease is normal during the
break‑in period on a new set of seals.
2. Lubricate the following with Quicksilver or Mercury Precision
Lubricants 2‑4‑C with Teflon or Special Lubricant 101.
Tube Ref No.
Special Lubricant 101
34
2-4-C with Teflon
95
• Swivel bracket ‑ Lubricate through fitting.
MAINTENANCE
a
Description
77
b
28691
Where Used
Swivel bracket, tilt
support lever, tilt
tube, steering cable
grease fitting
Swivel bracket, tilt
support lever, tilt
tube, steering cable
grease fitting
Part No.
92-802865Q0
2
92-802859A
1
Advertisement
Table of Contents
