Carrier Touch Pilot Manual page 20

General Configuration Menu – GEN_CONF(continued)
No. Name Status
25 ice_cnfg no/yes
26 al_rever no/yes
*Depends on the selected language (English by default).
Pump Configuration Menu – PUMPCONF
No. Name Status
1 hpumpseq 0 to 4
2 cpumpseq 0 to 4
3
4
5
6
7
8 pump_del 24 to 3000
9 pump_per no/yes
10 pump_sby no/yes
11 pump_loc no/yes
12 stopheat no/yes
13 stopcool no/yes
*Depends on the selected language (English by default).
User Configuration Menu – USERCONF
No. Name Status
1 use_pass 0 to 9999
*Depends on the selected language (English by default).
Reset Configuration Menu – RESETCFG
No. Name Status
1 cr_sel 0 to 3
2 hr_sel 0 to 3
3
4
5
6
7
8 dt_cr_no 0 to 13.9
9 dt_cr_fu 0 to 13.9
10 v_cr_no 0 to 20
11 v_cr_fu 0 to 20
12 spacr_no -10 to 51.7
13 spacr_fu -10 to 51.7
14 cr_deg -16.7 to 16.7
20
Default Unit Displayed text*
no - Ice Mode Enable
no - Reverse Alarms Relay
Default Unit Displayed text*
0 - Condenser Pumps Sequence
0 - Cooler Pumps Sequence
0 = No Pump
1 = One Pump Only
2 = Two Pumps Auto
3 = Pump#1 Manual
4 = Pump#2 Manual
48 hour Pump Auto Rotation Delay
no - Pump Sticking Protection
no - Stop Pump During Standby
yes - Flow Checked If Pump Off
no - Cooler Pump Off In Heat
no - Cond Pump Off In Cool
Default Unit Displayed text*
11 - User Password
Default Unit Displayed text*
0 - Cooling Reset Select
0 - Heating Reset Select
0=None, 1= Delta T
2=4-20mA control T
3= Space Temp
Cooling
0 ^C Delta T No Reset Value
0 ^C Delta T Full Reset Value
0 mA Current No Reset Value
0 mA Current Full Reset Value
-10 °C Space T No Reset Value
-10 °C Space T Full Reset Value
0 ^C Cooling Reset Deg. Value
Description
Ice mode enabled
Alarm / Alert signals reverted
No = standard operation
Yes = alarm/alert/shutdown outputs are "On" even
if there is no alarm/alert (alarm output unavailable)
Description
Condenser pumps' sequence: This unit can
control only one condenser pump. This value
can be set to "0" or "1".
Evaporator pumps' sequence
0 = No Pump
1 = One Pump Only
2 = Two Pumps Auto (units with two pumps)
3 = Pump#1 Manual
4 = Pump#2 Manual
Pump auto rotation delay (units with two
pumps = auto control)
Pump anti-sticking protection
Not applicable to this unit
Water flow is checked when the pump is off
Evaporator pump OFF in heating
Condenser pump OFF in cooling
Description
User password: The user password can be
modified by changing the value in this line
Description
Cooling reset selection
Heating reset selection
0 = None, 1 = Delta T
2 = 4-20mA control
3 = Space temperature
Cooling
Delta T, no reset value
Delta T, max. reset value
Current, no reset value
Current, max. reset value
Space temperature, no reset value
Space temperature, max. reset value
Maximum cooling reset value