Extron electronics NAVigator Setup Manual page 6

NAVigator • Setup Guide (Continued)
Discover and assign encoders and decoders
Discover and assign encoders and decoders (endpoints) to the NAV system as follows:
You can also pair encoders and decoders to each other using the device ID buttons on the endpoints (see the applicable
NOTE:
encoder and decoder guides available at www.extron.com).
Press and release the device ID button on the front panel of an endpoint to highlight the ID field on the HTML page for that
TIP:
endpoint (see figure
1. On the home page, if necessary, click the Menu link (see figure 8,
Assign Endpoints panel opens (see
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
Figure 8.
Discover Endpoints
:
If you are adding to an existing set of assigned endpoints, at this point the endpoints pane shows the existing endpoints.
NOTE
Click the Discover link instead (see figure 9,
Figure 9.
Appearance of Endpoints Panel when Adding to Existing Endpoints
6
10, on page 7). This can help identify the device. Press and release the button again to clear the highlight.
3
figure 10).
). Click Endpoints (
1
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
1 ) to add new endpoints.
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
) > Discover Endpoints (
2
). The
3