BLOTZ B10-RD-103 Instructions

PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Start by removing the sections shown above from
the sprue.
Then glue the side sections and central barriers
into place – again using the lugs/holes provided.
Leave to dry.
10mm Flyover – Damaged Section
B10-RD-103
Please read these instructions fully before starting construction.
Glue a cross supports to the underside of each
roadway using the lugs/holes provided as shown
above.
To attach the support columns, simply slide the cross
support into the notches in the support column arms.
We suggest that you do not glue these into place as it
will make set-up and storage easier.