BLOTZ B06-CS-101 Quick Start Manual

BLOTZ B06-CS-101 Quick Start Manual

6mm 'd' tower block foyer

Advertisement

PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B06-CS-101)
Remove the pieces shown above from the sprue.
(The side walls are marked 'L' and 'R'
respectively).
Glue the front and side walls to the main support
as shown above. Allow to dry.
Glue the canopy to the rear wall, then attach that
wall and the two side walls to the main support.
6mm 'D' Tower Block Foyer
B06-CS-101
Please read these instructions fully before starting construction.
Glue the canopy and archway to the front of the
building as shown above.
Remove the rear walls and rear canopy from the
sprue.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B06-CS-101 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BLOTZ B06-CS-101

  • Page 1 During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while you allow glue to dry. Foyer (B06-CS-101) Glue the canopy and archway to the front of the building as shown above.
  • Page 2 6mm ‘D’ Tower Block Middle B06-CS-151 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
  • Page 3 6mm ‘D’ Tower Block Roof B06-CS-201 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.

Table of Contents