BLOTZ B15-ME-104 Manual

BLOTZ B15-ME-104 Manual

15mm desert fort-corner tower

Advertisement

15mm Desert Fort – Corner Tower
B15-ME-104
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Attach the connector pieces.
Take the tower roof and the two thinner tower
wall pieces.
Glue them together as shown above – Note the
angled supports have an arrow on them which
should point upwards.
Attach the walkway section.
Add them to the model as shown.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B15-ME-104 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BLOTZ B15-ME-104

  • Page 1 15mm Desert Fort – Corner Tower B15-ME-104 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
  • Page 2 Add the other two tower wall pieces. Add the front wall sections. The finished model.

Table of Contents