BLOTZ B10-MW-112 Instructions

10mm 5x1 mixed foyer

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due

care and remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold

pieces in place while you allow glue to dry.

Foyer (B10-MW-112)

Start by removing the sections shown above

(right) from the sprue. There are enough parts to

create all four doorway sections.

Glue them together as shown in the image on the

left.

At the same time, glue a triangular bracer to the

back of the long sides at each end. Leave these to

dry.

10mm 5x1 Mixed Foyer

B10-MW-112

Please read these instructions fully before starting construction.

Glue the doorways to the back of the long sides, using

the lugs/holes provided.

Glue the two end walls into place then add the

decorative columns.

Table of Contents

Do you have a question about the B10-MW-112 and is the answer not in the manual?

Page 1 During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while you allow glue to dry. Foyer (B10-MW-112) Start by removing the sections shown above (right) from the sprue. There are enough parts to Glue the doorways to the back of the long sides, using create all four doorway sections.
Page 2 10mm 5x1 Mixed Middle B10-MW-157 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 3 10mm 5x1 Mixed Roof B10-MW-207 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.