Freedom Inverter/Charger Configuration - Xantrex FREEDOM HF 1000 Owner's Manual

Freedom Inverter/Charger Configuration

Setting Battery Types on the Main Unit
You can attach different types of lead-acid batteries to the Freedom HF.
Before installing batteries make sure that you configure the unit to optimize
the charging process.
The settings can be changed by adjusting the dip switches found on the
main unit behind the display panel.
Battery Dip Switch Setting
Type Switch 1|Switch 2
Fixed OFF|OFF
Flooded OFF|ON (default)
GEL ON|OFF
AGM ON|ON
975-0390-01-01
Bulk/
Absorption Float
13.5 13.5
14.4 13.5
14.2 13.8
14.3 13.4
To adjust the battery type setting:
By default the battery type is set to Flooded (OFF|ON).
1. Detach the Display Panel to expose the Dip Switches.
2. Use the tip of your fingernail or a small screw driver with a flat tip to
adjust the switches.
OFF
Switch 1 | Switch 2
Figure 2 Dip Switches (Default Settings Shown)
ON
9