Printing - Sony UP-DR80MD Instructions For Use Manual

Printing

Before printing
• Is the printer connected to a computer? (page 14)
• Has the printer driver been installed? (page 14)
• Has the media tray been properly loaded? (page 16)
1 On/standby switch
Paper cover
Stopper
1
Press the printer 1 On/standby switch to turn on the
power of the printer.
The 1 On/standby indicator lights and initialization
of the printer begins.
The PRINT, ALARM, RIBBON/PAPER, and TRAY
LOCK indicators light simultaneously during
initialization of the printer, and go out when
initialization is complete.
2
Turn the computer on.
3
Using the computer, initiate a printing operation.
The PRINT indicator flashes while the image data is
being received, and then remains steadily lit while
printing is in progress.
Notes
• Do not place objects on the paper cover that will
obstruct printing. Doing so may result in damage.
• Although the paper being printed may come into
view in the paper outlet while printing is in
progress, do not touch the paper until printing is
completed. Doing so could result in misoperation.
• Do not allow more than 10 printouts to accumulate
on the paper cover. Leaving too many printouts on
the paper cover could cause a paper jam.
• Do not press the 1 On/standby switch to enter the
standby state while printing is in progress. Doing so
may cause a paper jam or the ink ribbon to break.
20
Printing
Paper outlet
STOP button
• Do not open the media tray while printing is in
progress.
If the media tray is opened, printing stops and the
PRINT, ALARM, RIBBON/PAPER, and TRAY
LOCK indicators all light simultaneously. In such
an event, press the 1 On/standby switch once to
enter the standby state and then press the switch
again to turn the printer ON, and check that there is
no paper jam or the ink ribbon is not broken. Also,
if printing was partway through, cut off the used
part of the paper roll with a pair of scissors or the
like before using the printer.
Notes
Storing printed images
• Avoid storing printouts in a location subject to high
temperatures, high humidity, excessive dust or direct
sunlight. Such conditions could result in fading.
• Do not stick tape on a printout. Also, do not let printouts
come into contact with materials which contain
plasticizers, such as erasers or desk mats.
• Do not allow volatile organic solvents, such as alcohol,
to come into contact with printouts.
Cancelling continuous printing
Press the STOP button. Printing of the current item
finishes, and then the printer enters the ready state once the
printout is ejected.
When printing is disabled
The printer will not operate if the ALARM, RIBBON/
PAPER or TRAY LOCK indicator is on. For details, see
"Explanation of Indicators" on page 28.
If the ink ribbon runs out while continuous
printing
The printer terminates the printing operation. Once the
new ink ribbon is loaded, the printing operation
automatically resumes and the remaining images are
printed.
Using the stopper
To prevent ejected printouts from falling off of the paper
cover, insert your finger in the depression on the edge of
the stopper and then flip the stopper up in the direction
indicated by the arrow in the diagram below.