Installation Surface; Removing The Transit Bars - Miele PWM 908 Operating And Installation Instructions

Installation

Installation surface

A concrete floor is the most suitable
installation surface. It is far less prone
to vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
 The machine must be level and
securely positioned.
 To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
 Install the machine on a plywood
base (at least 70 x 60 x 3 cm). The
base should span several joists and
be bolted to the joists and not only to
the floorboards.
Useful tip: If possible, install the
machine in a corner of the room. This is
usually the most stable part of the floor.
74

Removing the transit bars

 Remove the left and right covers.
1. Pull off the transit bar covers and
2. and use a screwdriver to release the
catches at the top and bottom.
 Using the spanner supplied, turn the
left-hand transit bar 90°.