Intec FORCE/2 Instruction Manual page 9

THE FORCE/2
Overview, Cont.
THREE SUBSYSTEMS MAKE UP YOUR FORCE/2:
1. THE AGITATOR AND AIRLOCK.
⁄ or 2 horsepower motor driving an enclosed gearbox. The gearbox drives both
1
2
the agitator and airlock components at a constant speed.
2. THE BLOWER MOTOR.
a 105 or 116 CFM two-stage blower motor to push the material through the
hose and into the attic with optimum pressure and output. The blower is
connected to the air intake port of the airlock by a plastic hose.
3. ELECTRICAL COMPONENTS.
dedicated 20 amp grounded outlets. A circuit (outlet) rated lower
than 20 AMPS may cause premature tripping at the power source.
Always disconnect the power
cords before beginning any
maintenance. And as with all
electrical systems, never attempt
to operate your FORCE/2 with
either the operator or the
machine standing in water.
SYSTEM COMPONENTS.
A. Hopper: Upper component of the FORCE/2 where insulation
is loaded.
B. Base: Lower component of the FORCE/2 houses power
components, agitator motor, blower, gearbox, airlock and electrical
system.
C. Slide gate: Regulates the amount of material entering the airlock.
D. Electrical: Operates the on/off function of both the blower and
agitator motors.
E. Remote: Allows the control of the on/off function of both the
blower and agitator motors via a 100" control cable.
Your FORCE/2 runs on a 1-
Your FORCE/2 is equipped with either
Your FORCE/2 requires two
(See next page for drawings.)
7