Intec FORCE/2 Instruction Manual page 28

THE FORCE/2
T roubleshooting, Cont.
Problem Likely Cause
Machine makes a Gearbox drive not
grinding noise when engaged with airlock
running. rotor connection out
of alignment.
Low oil level in gearbox.
Agitator fan cover rubbing
against rotating fan blade.
Decreased material Worn airlock seals.
throw.
Kink in hose.
Excess air leaking into
hopper.
Material buildup in
blower housing.
Machine does not run Remote cord not plugged
into electrical panel
Blower power cord is not
plugged in at main panel
or power cord does not
have electrical power at
source.
No power.
Remedy
Loosen gearbox and
gearbox stabilizers. Align
gearbox and airlock shaft
perpendicular to each other.
Resecure bolts. Replace
gearbox stabilizers if bent.
Have the gearbox
inspected and repaired by a
qualified service center. See
gearbox section for oil capacity.
Remove black plastic cover
on outside of machine.
Remove agitator motor fan
cover and inspect fan blade
and bend cover back to
normal condition.
Inspect seals for tears or
cuts. See maintenance
section to replace or adjust
as necessary.
Run hose as straight as
possible to help maintain
production.
Inspect seals for tears or
cuts. See maintenance
section to replace or adjust
as necessary.
Turn machine upside down
and use compressed air to
blow out air intake. See
diagram.
Plug in remote cord into
electrical panel and position
the agitator and blower switch
to the on position.
Check connection on power
cord at main panel or
make sure electricity is
present at power source.
Check source of electrical
power. Possible tripped
circuit breaker.
26