Intec FORCE/2 Instruction Manual page 26

Hide thumbs Also See for FORCE/2:

Table of Contents

THE FORCE/2

Maintenance, Cont.

REPLACING BLOWER BRUSHES

Model 21025

(105 CFM)

brush replacement not recommended

Model 21024

(116 CFM) shown

Removing old brushes: Disconnect all

electrical cords to machine. Tip machine

upside down onto hopper. To facilitate

replacement of the blower brushes

remove blower from machine. Locate

brush clips (fig 1), using flat

screwdriver place screwdriver under brush clip as shown (fig 2), pry in an upward

motion until loose. Remove brush clip and brush assembly from motor housing

(fig 3). Remove wire connector from tab on brush assembly (fig 4).

Installing new brushes: Push wire connector onto brush tab and ensure

connection is secure. Insert brush into housing with the tab and wire in the down

position. Slide brush assembly all the way into motor housing until it stops. Push

down and inward on brush assembly, slide brush clip into top of motor housing to

secure brush assembly (fig 5). When finished make sure the brush clip is flush or

below motor housing (fig 6).

Note: Brush clip can only be installed one way. Do not force

brush clip into motor housing or damage may occur!

blower clip

fig 3

fig 1

fig 2

fig 4

fig 5

fig 6

Table of Contents

Show Quick Links

Table of Contents