LG Pro Centric 55ET960H Setup Manual page 74

IP Environment Setup (Cont.)
(Continued from previous page)
RF Configuration
For TVs in Pass-through Mode or FTG Mode, if the Data Channel is left at its
default value (AUTO), the TV's Data Channel Auto Search feature will be
enabled. See Installer Menu item 119 DATA CHANNEL description on page 49.
• To change the Data Channel setting, select/highlight the Data Channel
field and press the Wheel (OK) button on the Installer Remote. Then,
use the Up/Down arrow keys to select either MANUAL or AUTO from
the drop-down list of options.
• When the Data Channel field is set to "MANUAL," a data entry field is
available on the screen, and you can specify the RF channel number
that will be used by the Pro:Centric server as its data channel. The Data
Channel value can be set from 0 (disabled) to 135.
Use the arrow keys on the Installer Remote to select the Data Channel data
entry field and press the Wheel (OK) button. You can then use the number
keys on the Installer Remote to direct enter the Data Channel, or you can use
the arrow keys to select the appropriate number(s) from the pop-up virtual
keyboard displayed at the bottom of the screen. When you are done, select
Enter from the virtual keyboard, and then press the Wheel (OK) button on
the Installer Remote.
Note: If the Data Channel has already been set in the Installer Menu (item
119) or in the EZ-Manager Wizard, the specified channel will appear in the
Data Channel data entry field. If you change the Data Channel in this menu,
Installer Menu item 119 will now show the value you entered here.
IP Configuration
Note: If the server IP address and port number or domain name have already
been set in the EZ-Manager Wizard, the specified data will be reflected in the
fields displayed.
Note: Setting the Media Type to "IP" automatically sets item 119 DATA
CHANNEL in the Installer Menu to 253. You cannot alter this setting unless
you revert Media Type to "RF." Also, it is not possible to direct enter "253" in
the Installer Menu.
a) The Server Address field provides the option to specify the domain name
of the Pro:Centric server instead of the server's IP address. Select/highlight
the Server Address field and press the Wheel (OK) button on the Installer
Remote. Then, use the Up/Down arrow keys to select either IP Address or
Domain Name from the drop-down list of options for defining the server.
b) Depending on your selection in the previous step, either:
• Select the appropriate IP type (either IPv4 or IPv6) in the IP Type field,
and then enter the Pro:Centric server IP address in the IP Address field.
The IP address must match the IPv4 or IPv6 (as applicable) address
that is set in the Pro:Centric server.
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
74
*
(Continued on next page)
206-4350