LG Pro Centric 55ET960H Setup Manual page 19

(Continued from previous page)
Note: If a cable is not currently connected between the TV and the network and you do not want
to configure/complete configuration of network settings at this time, you can select/highlight
SKIP, and press the Wheel (OK) button on the Installer Remote to continue to the next step.
Configure a Wired Network Connection
NETWORK SETTINGS
Configure network settings.
Network Connection Type
^
Wired (Ethernet)
Advanced Options
IPv6
^
Disabled
Automatically Assign IP Address
IP Address
10.1.2.3
Subnet Mask
255.255.255.0
NEXT
BACK NEXT This wizard will continue automatically in 10 seconds.
a. If not already done, connect the appropriate cable between the TV and the network.
b. Make sure the Wired (Ethernet) option is selected in the Network Connection Type field,
and then press the Wheel (OK) button on the Installer Remote.
c. By default, the TV uses DHCP, and if a LAN is detected, the TV will request an IP address
from the DHCP server on the network. If the TV is able to connect to the network, the network
configuration data will be displayed on the screen as shown in the example above.
If the network is not configured for DHCP, or if you want to enable/disable IPv6 or specify
static IP configuration data, continue with steps (d) and/or (e), respectively.
d. (Optional) To enable IPv6, select/highlight the IPv6 field and press the Wheel (OK) button.
Then, select Enabled from the drop-down list of options.
e. (Optional) If required, you can edit the IP data for this TV as follows:
• De-select the "Automatically Assign IP Address" checkbox under "Advanced Options."
• For each data entry field: Use the arrow keys on the Installer Remote to select the field and
press the Wheel (OK) button. You can use the number keys on the Installer Remote to
direct enter numeric values or use the arrow keys to select the appropriate alphanumeric
characters (as applicable) from the pop-up virtual keyboard displayed at the bottom of the
screen. When you are done, select Enter from the virtual keyboard, and then press the
Wheel (OK) button on the Installer Remote.
Note: For IPv4, you must use the dot "." key from the virtual keyboard to separate each
octet of an IP address. For IPv6, you must use the colon ":" key from the virtual keyboard to
separate each group of an IP address.
206-4350
^
^
Basic Settings Wizard (Cont.)
X
02
(Continued on next page)
19