oventrop Aktor M ST L Operating Instructions Manual page 11

„Aktor M ST L"
1. Completely disconnect the actuator from the power
supply.
2. Check the lift position of the actuator.
3. If the actuator is not in the upper lift position (see
position (1) in Illust. 10 on page 10):
Open the cover for manual setting (adjustment
spindle) (see position 2 in Illust. 9 on page 10)
and move the actuator to the upper lift position
using a 4 mm Allen key.
NOTICE
Malfunction due to manual over-tight-
ening
Fault-free operation of the actuator is not
guaranteed if the slip clutch is triggered
during manual setting.
f After having reached the manually set
lift position, turn the Allen key by half
a turn in the opposite direction!
4. Loosen the collar nut.
Z The actuator can be removed.
10. Reinstallation
The actuator must be in the upper lift position
for correct installation.
1. Before reinstalling, move the actuator to the upper
lift position as described in section 9 on page 10.
2. Fit the actuator to the connection thread of the
valve.
3. Hand tighten the collar nut.
4. Put the actuator into operation as described in sec-
tion 6 on page 9.
After reinstallation, an initialisation run will only
be triggered if one of the DIP switches 1 to 6
(see Illust. 4 on page 9) is readjusted after
connection to the power supply.
The initialisation run will neither be triggered
after a reconfiguration if the actuator is already
in the upper lift position.
101272584-V01.11.2019
11. Disposal
Directive 2012/19/EU WEEE:
Old appliances must not be disposed of with
standard waste, but must be dropped off at
a collection point for the recycling of electri-
cal and electronic appliances.
NOTICE
Risk of environmental pollution
Incorrect disposal (for instance with standard
waste) may lead to environmental damage.
f Dispose of packaging material in an envi-
ronmentally friendly manner.
f Dispose of the components appropriately.
If no return or disposal agreement has been made,
dispose of the product yourself.
f If possible, recycle the components.
f Dispose of components which cannot be recycled
according to local regulations. Disposal with the
standard waste is not permitted.
Reinstallation
11