Step 4: Set Up A Serial Connection To The Array - Dell EqualLogic PS Series Installation And Setup Manual

Installation and Setup
Note: Batteries will start to charge and some hardware components will start to
synchronize when power is turned on. Array LEDs indicate this activity,
which is normal array behavior.
To install and lock the bezel:
1. Facing the front of the rack, fit the right side of the bezel into the right side of
the chassis.
2. Push the bezel toward the chassis until the left side of the bezel engages with
the chassis.
3. Insert the bezel key and turn it counter-clockwise to lock the bezel to the
chassis.

Step 4: Set Up a Serial Connection to the Array

If you plan to use the
serial connection. If you plan to use the Remote Setup Wizard, you do not need a
serial connection. See Step 1: Choose a Configuration Method on page 3-1 for
information about Remote Setup Wizard requirements.
Note: The serial cable that was shipped with the array is a standard null-modem
cable with a female DB9 connector on each end. You might have to make
or buy an adapter cable (one DB9 connector and one RJ45 connector) to
connect the array to some models of terminal server. See Figure 2-7 and
Table 2-5 on page 11 for the connector pinout information.
Attach the serial cable to the serial port on the active control module (ACT LED
will be green) and to a console terminal or a computer running a terminal
emulator. See Figure 2-22 (not to scale).
2–26
utility to configure the software, you must set up a
setup
Installing a PS6500 Array