Dell EqualLogic PS Series Installation And Setup Manual page 31

Installation and Setup
cables have sufficient slack between the array back panel and the first
connection to the cable management system ( ).
2. Connect all three fasteners on the arm and place the cables below the arms.
See Figure 2-15.
Figure 2-15: Attaching the Hook-and-Loop Fasteners
3. Route the cables along the middle arm of the three-arm assembly, going from
to in Figure 2-14.
4. Route the cables along the one-arm assembly (connected to the top of the left
and right rails), going from
After routing the cables, the installation should resemble Figure 2-16.
Figure 2-14: Cable Routing Diagram
to
Installing a PS6500 Array
in Figure 2-14.
2–21