Table of Contents
Advertisement
99
Initial Filling or Rinsing of the Entire Interchangeable Unit
2.7.4
While the initial filling or rinsing programme is being run, please place a sufficiently dimensioned waste
vessel under the titration tip.
Initial filling of the interchangeable unit is done using the «rinsing» program.
Fig. 19
On the main menu (Fig. 19), press <MODE> to navigate to the methods/system (Fig. 20).
Fig. 20
Pressing <↑> twice will take you to the «Rinsing» selection immediately (Fig. 21).
Fig. 21
Confirm the selection by pressing <ENTER>/<OK>.
At this point you can select the number of rinsing cycles (Fig. 22).
Advertisement
Table of Contents
