Table of Contents
Advertisement
8.4
Automatic stirrer control
General
8.4.1
If the magnetic stirrer TM 235 is connected via USB, the stirrer can be controlled via the piston burette.
A suitable connection cable is included with the TM 235.
Basic setting in the system menu
8.4.2
Connect the magnetic stirrer with the USB cable to one of the two USB A sockets.
Under «System Settings», select «Stirrer Control» (Fig. 170).
Fig. 170
Confirm the selection with <ENTER>/<OK>. The default setting is set to «free». The stirrer control thus only
works with the thumb wheel on the magnetic stirrer (Fig. 171).
Fig. 171
If you want to deactivate the stirring speed when switching on, you must select the speed «0» level (Fig. 172).
Fig. 172
161
Advertisement
Table of Contents
