Mounting On The Simatic Et 200Sp - Siemens SIMATIC ET 200SP Manual

4.3

Mounting on the SIMATIC ET 200SP

The electronic weighing system described here is a module of the SIMATIC ET 200SP series
and can be directly connected to the automation system's bus system. The 15 mm wide module
has very low installation and cabling requirements.
The module is snapped onto the ET 200SP base unit (BU). You must use base units of type
A0 (→ Accessories (Page 55)).
The load cells, power supply and serial interfaces are connected via the terminal box.
Figure 4-1
Analog input module AI 2xSG 4-/6-wire HS (7MH4134-6LB00-0DA0)
Manual, 09/2018, A5E41867508A-AB
Installation of the I/O or SIWAREX modules
4.3 Mounting on the SIMATIC ET 200SP
Mounting
17