Set Indoor Station Network Parameters; Set Linked Device Ip - HIKVISION KH6 Series Configuration Manual

Configuration settings is required before starting using the indoor station. It is
necessary to set the indoor station network, room No., linked devices, device time
display, and so on.

1.2.1 Set Indoor Station Network Parameters

Network connection is mandatory for the use of the indoor station. Set the network
parameters after activating the indoor station. Only when the IP address of the
indoor station is in the same network segment as other devices, it can work properly
in the same system.
Steps
Note
The default IP address of the indoor station is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1. Tap Settings →
2. Tap
to enter the network settings page.
3. Set the network parameters.
Enable DHCP, and the system can assign an IP address of the indoor station
-
automatically.
Disable the DHCP function, and set the IP address manually. You should set
-
the device IP address, the gateway, the DNS address.

1.2.2 Set Linked Device IP

Network Indoor Station Configuration Guide
→ Configuration , and enter admin (activation) password.
Figure 1-2 Network Settings
2