Table of Contents
Advertisement
Setup
Wireless Operation
In optimal conditions, the WELL Gobo can operate up to 300 m (900 ft) away from the W-DMX transmitter.
The W-DMX receiver in the WELL Gobo must be paired with the W-DMX transmitter for wireless operation.
Once a WDMX receiver has been linked to a specific WDMX transmitter, it will remain linked
to that specific transmitter until it is linked to a different one.
Initial Setup
1. Turn the W-DMX transmitter on.
2. Connect the W-DMX transmitter to a DMX controller.
3. Place the WELL Gobo within 300 m from the W-DMX transmitter.
4. Turn the WELL Gobo on.
Configuration
1. From the WELL Gobo control panel, go to DMX Address.
2. Select the start address, as with any other DMX-compatible product.
3. Go to Wireless Setting > Receive.
4. Select Receive.
5. Select On. (The Signal Strength Indicator will show a ? in front of the bars).
6. Press the reset button on the W-DMX transmitter.
(The Signal Strength Indicator on the WELL Gobo will show a ϟ in front of the bars for 3 seconds
while a connection is established.).
Product Pairing
If the WELL Gobo has already been paired with the W-DMX transmitter, the Signal Strength Indicator in the
middle of the LCD screen will show the strength of the signal. In this case, the WELL Gobo is ready to work
in Wireless mode.
Pairing the WELL Gobo and a new W-DMX transmitter:
1. From the WELL Gobo control panel, go to Wireless Setting > Receive Reset.
2. Select Yes. The Signal Strength Indicator on the WELL Gobo will show a ? in front of the bars.
3. From the W-DMX transmitter, press <RESET> (the Signal Indicator on the transmitter will flash).
4. Once the transmitter has found the WELL Gobo, the Signal indicator on the W-DMX transmitter
will illuminate solid.
5. The Signal Strength Indicator in the middle of the LCD screen on the WELL Gobo will show the
strength of the signal.
W-DMX operation can be interrupted or inhibited by liquid masses between the transmitter
and receiver such as water, snow, or people. For best results, keep the area between the
transmitter and receiver clear of any liquid mass.
Storage Notes
•
Store charged product(s) in a dry environment, away from direct sunlight.
•
Charge or discharge the battery to approximately 50% of capacity before storage.
•
Lithium-Ion batteries continue to slowly discharge (self-discharge) when not in use or while in
storage. Routinely check the battery's charge status
•
Store the battery at temperatures between 41 °F and 68 °F (5 °C and 20 °C).
WELL Gobo User Manual Rev. 1
Page 7 of 17
Advertisement
Table of Contents
