Safety Instructions And Measures - Samson 41-23 Mounting And Operating Instructions

Safety instructions and measures

1 Safety instructions and measures
Intended use
The SAMSON Type 41-23 Regulator is a pressure regulator. It consists of a Type 2412 Valve
and a Type 2413 Actuator. The valve and actuator (except for tested regulators) are deliv-
ered separately and must be assembled together according to these instructions.
The self-operated regulator is used to control the downstream pressure p in the pipeline to
2
the adjusted set point. Liquids, gases and vapors in processing and industrial plants can be
controlled by the regulator.
The regulators are designed to operate under exactly defined conditions (e.g. operating pres-
sure, process medium, temperature). Therefore, operators must ensure that the regulators are
only used in operating conditions that meet the specifications used for sizing the devices at
the ordering stage. In case operators intend to use the regulators in other applications or
conditions than specified, contact SAMSON.
SAMSON does not assume any liability for damage resulting from the failure to use the de-
vice for its intended purpose or for damage caused by external forces or any other external
factors.
Î Refer to the technical data and nameplate for limits and fields of application as well as
possible uses.
Reasonably foreseeable misuse
The regulators are not suitable for the following applications:
− Use outside the limits defined during sizing and by the technical data
− Use outside the limits defined by the additional fittings mounted on the regulator
Furthermore, the following activities do not comply with the intended use:
− Use of non-original spare parts
− Performing service and repair work not described in these instructions
Qualifications of operating personnel
The regulator must be mounted, started up, serviced and repaired by fully trained and quali-
fied personnel only; the accepted industry codes and practices are to be observed. Accord-
ing to these mounting and operating instructions, trained personnel refers to individuals who
are able to judge the work they are assigned to and recognize possible hazards due to their
specialized training, their knowledge and experience as well as their knowledge of the appli-
cable standards.
EB 2512 EN 1-1