Replacing Or Installing The Front Port Panel; 5-11 Optional Front Bezel - Supero SC825 Series User Manual

SC825 Chassis Manual

Replacing or Installing the Front Port Panel

Replace or Install the Front Port Panel
1. Power down and unplug the power cord from the rear of the power supply.
2. Remove the chassis cover.
3. Disconnect the power and data cables from the front port panel to other chassis
components including the motherboard and backplane.
4. Remove the old port panel by depressing the release tab, then pulling the unit
out of the chassis.
5. Insert the new front port panel unit in the slot until the tab locks into place.
6. Connect the data and power cables to the backplane and motherboard.
For more information, see the manual for your backplane in the appendix.
5-20

5-11 Optional Front Bezel

The SC825 chassis supports an optional full-face locking front bezel for added se-
curity. The front bezel is not included with the SC825 chassis, but can be ordered
seperately by visiting the Supermicro website at www.supermicro.com, clicking on
the Where to Buy link and referencing part number MCP-210-82503-0B.
Chapter 5: Chassis Setup and Maintenance
5-21