Removing The Chassis Cover; Installing Hard Drives - Supero SC825 Series User Manual

SC825 Chassis Manual
5-3

Removing the Chassis Cover

1
1
Remove
Screw
2
2
Release Tab
Figure 5-1. Removing the Chassis Cover
Removing the Chassis Cover
1. Power down the system and remove the power cords from the rear of the
power supply.
2. Remove the two screws on each side of the cover, which secure the cover to
the chassis.
3. Press the release tabs to remove the cover from the locked position. Press
both tabs at the same time.
4. Once the top cover is released from the locked position, slide the cover
toward the rear of the chassis.
5. Lift the cover off the chassis.
Warning: Except for short periods of time, do NOT operate the server without the
cover in place. The chassis cover must be in place to allow proper airflow and prevent
overheating.
4
3
1
1
Remove
Screw
5-2
5-4

Installing Hard Drives

2
Figure 5-2. Removing Hard Drive
The SC825 features hot-swappable hard drives which can be removed without
powering down the system.
Removing Hard Drive Trays from the Chassis
1. Press the release button on the drive carrier. This extends the drive carrier
handle.
2. Use the handle to pull the drive out of the chassis.
Chapter 5: Chassis Setup and Maintenance
1
5-3