Operation - Baileigh Industrial BS-350SA Operator's Manual

OPERATION

CAUTION:
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy materials make sure they are properly supported.
• Turn the main disconnect switch (AC) to "ON". Power indicator light (Y) will illuminate.
• Select the blade cutting speed with knob (X). (indicator light will blink as selection is made).
Note that knob has an on/off feature.
• Press hydraulic pump start switch (AD). If the hydraulic pump does not start, switches (Z),
(AA), and (AE) will not work. The indicator light on switch (AD) will blink if any of them are
pressed.
• Press switch (Z) or (AA) to adjust the bow height as necessary. The up limit switch must be
activated (depressed) to start a cut cycle. Either raise the bow to the switch or adjust the
switch to the bow. See Saw Bow Stroke Limiting.
• Place the piece part in the vise and adjust the clamp from tight to not more than 1" (25mm)
away from the material.
• Method (1), press switch (AB) to select the hand or foot pedal operation
• For Hand, press switch (AE) cycle start to begin the sawing operation.
• For Foot pedal, step on the footswitch to start the sawing operation.
Always wear proper eye protection with side shields, safety
X
Y
AC
Z AA
AD
40
40
AB
AE