Operation; Manual Operation - Baileigh Industrial BS-210M Operator's Manual

OPERATION

CAUTION:
footwear, and leather gloves to protect from burrs and sharp edges.
NEVER operate saw without blade guards in place.

Manual Operation

1. Close the handle on the hydraulic ball valve (I) by turning it
counterclockwise (ccw).
2. Turn the flow control knob (AH) clockwise (cw) to shut off the
hydraulic flow. This will prevent the saw bow from dropping
when the ball valve is opened.
3. Reduce the bow weight. Rotate the wing nut (AI) clockwise (cw)
to increase the tension on the spring.
4. Load piece part and clamp securely.
5. Turn the main switch (A) to "ON". Check to see that the indicator
light (B) is lit.
6. Set the blade speed with control knob (E).
7. Set switch (G) to manual mode for trigger operation.
8. While firmly holding the control handle of the saw bow, open ball
valve (I) clockwise (cw).
9. Fully open the flow control knob (AH) counterclockwise (ccw).
10. Squeeze the start trigger to energize the blade motor and lower
saw bow to begin cutting.
11. When saw bow reaches bottom limit, the
micro switch (M) is actuated and shuts off the
saw motor.
12. Return the saw bow to its start position and
close ball valve (I).
13. Unclamp and reset the piece part to continue
the next cutting cycle.
Always wear proper eye protection with side shields, safety
27
27
I
AH
AI
M